Engineering :: Production Engineering
|
|
|
|
|
741. |
Plate liners used between the vice-jaw and the work piece are made of |
A. |
Copper or Tin |
B. |
Mild steel |
C. |
Hard steel |
Answer: Option A
Explanation:
|
742. |
Device used in the fitting shop used for holding round bars during marking/centre drilling thin faces is known as |
A. |
V-block |
B. |
Bench vice |
C. |
Surface plate |
Answer: Option A
Explanation:
|
743. |
Material used for surface plate in fitting shop is |
A. |
Cast iron |
B. |
Mild steel |
C. |
Cast steel |
Answer: Option A
Explanation:
|
744. |
The length of hacksaw blades is |
A. |
200 - 300 mm |
B. |
300 mm - 400 mm |
C. |
150 mm - 250 mm |
Answer: Option A
Explanation:
|
745. |
Usual thickness of a hacksaw blade is |
Answer: Option A
Explanation:
|
746. |
Usual width of a hacksaw blade is |
A. |
12.7 mm |
B. |
15 mm |
C. |
10 mm and above |
Answer: Option A
Explanation:
|
747. |
Hacksaw used for cutting steel, cast iron, aluminium etc, has the following number of teeth per centimeter |
Answer: Option A
Explanation:
|
748. |
Teeth of a hacksaw are |
A. |
Bent alternately in opposite directions |
B. |
Bent in one direction only |
C. |
In a single plane |
Answer: Option A
Explanation:
|
749. |
While cutting with a hacksaw, the number of teeth contacting the job should be |
A. |
More than one |
B. |
Only one |
C. |
Any of (A) or (B) |
Answer: Option A
Explanation:
|
750. |
The weight of hammers used in a fitting ship is |
A. |
0.45 kg - 0.70 kg |
B. |
0.75 kg - 1 kg |
C. |
0.25 kg - 0.50 kg |
Answer: Option A
Explanation:
|
Read more:
|
|